Thursday, February 13, 2020

3D Printer: Lulzbot TAZ 6 - Extruder Idler

Lulzbot TAZ6 Extruder Idler - I had to replace my extruder idler because it was not grabbing the filament (no pressure on the filament to go down) and sending to the printer's head. It's not perfect but works nice.

Doesn't matter, just in case: I have used Lulzbot mini 2
Material: Doesn't matter - I have used Polylite PLA 2.85 to generate the piece and also to print with the new extruder idler.

printed with: Generate Support AND NOT REMOVE the support
I have used the plastic tube as guide to filament to avoid some noise.


This thing was made with Tinkercad.
Based on:

No comments:

Post a Comment